Service & Support
How To Install Your EF1 Monitor
September 16, 2024
How to Install a TFT Parallel Shaft Gearbox
December 13, 2023
This video and article describe how to change the gearbox assembly on your TFT product. Tools Needed: 5/16” Allen Wrench A1633-KIT Procedure: Place your valve into the open position. Use a 5/16” allen wrench to loosen and remove the bolts on the existing gearbox. Remove the gearbox by pulling it upward. There is a […]
How to Adjust a Task Force Tips Pressure Relief Valve
December 6, 2023
If you need to adjust your pressure relief valve, the process is very simple. Tools Needed: ¼" allen wrench Adjusting the PRV Line the allen wrench up with the center key on the bottom of the PRV Turn the center plug until it is calibrated to the desired setting Reminders: Do not use a […]
How to Change Operating Modes on an RC Ball Intake Valve
November 22, 2023
If you have an RC Ball Intake Valve and need to switch operator modes, it is a simple process that involves pressing a button. Your BIV will come in Manual mode from the factory. This means when you push the open or close button, the valve will only move while you hold the button down. […]
Replacing Your Bail Handle and Valve Seat on a Ball Valve Nozzle
November 15, 2023
If it is time to replace your bail handle and valve seat on a ball valve nozzle, here’s how! Tools Required: Replacement Kit Hand Operated Drill or Drill Press Allen Wrench Hammer Seal Pick Small Punch Combination Wrench Procedure: Note: Some models will require removal of the coupling and others will not. Refer to […]
90-Degree Swiveling Hydrant Valve Use, Installation, and Maintenance
November 11, 2023
The 90-Degree Swiveling Hydrant Valve, or Swiveling Standpipe, can be installed on a wet pipe or dry pipe system. The valve rotates a full 360-degrees allowing you a simple connection to your hose. Operation works with a slow close valve mechanism for simplicity and control. With this piece of firefighting equipment, you can easily […]
Hydrant Under Monitor (HUM) Use, Installation, and Maintenance
November 10, 2023
A hydrant under monitor or HUM is a water distribution manifold that can be mounted on a wet or dry fire protection riser. The HUM allows you to simultaneously or individually control water supply to a high-volume STORZ connection, gated wye, and fire protection monitor. Separate valves control your water main and monitor for maximum […]
Replacing or Adding a Pistol Grip to Your Nozzle
October 18, 2023
If you have a broken pistol grip, need a new color of grip, or would like to add a pistol grip to your nozzle, the procedure is very simple. Follow along with this tutorial! Tools Required: 5/16” Ball End Allen Driver Pistol Grip Repair Kit HM692ORG-KIT – Orange HM692RED-KIT –Red HM692YEL-KIT – Yellow HM692WHT-KIT […]
Replacing Your Blitzfire Trip Mechanism
October 4, 2023
If your Blitzfire no longer holds its open position, it’s likely that your trip mechanism needs to be replaced. This repair can be done fairly quickly with a few tools. Let’s get started! Tools Required: XX910-KIT: Blitzfire trip mechanism replacement kit ¾” socket or combination wrench 5/32” Allen Wrench 7/32” Allen Wrench 1/8” Allen […]