How to Rebuild a Fire Nozzle Ball Shutoff Valve Summary: If your ball shutoff valve is leaking through the waterway when closed, start with the rear seat—it’s a quick fix that often solves the problem without a full teardown. If you see leakage from the trunnion areas or continued bypass after replacing the seat, a […]
How to Repair a Metro 1 Nozzle Tip Summary: If a Metro 1 fixed gallonage nozzle starts sliding instead of twisting, leaks from under the shaper, or seeps around the coupling, the usual fix is in the front end of the nozzle. Doug Heller walks through how to service the shaper, replace damaged Torlon guide […]
How to Replace Gated Wye Handles Summary: Replacing or upgrading Gated Wye handles is a straightforward service job that can improve valve operation depending on your department’s preference. Some firefighters prefer the added leverage and control of long folding handles, while others stick with short handles for their compact profile and reduced snag risk. This […]
How to Rebuild a Leaking 2.5″ Gated Wye Summary: If a 2.5″ x 1.5″ Gated Wye keeps dripping after shutoff, start with the valve seats. If it leaks on the 2.5″ inlet side, check the hose coupling gasket and make sure the inlet is actually tight enough to compress it. This rebuild uses basic hand […]
This guide walks you through how to test for low voltage and introduces TFT’s Pure Power, a plug-and-play solution to help stabilize power and prevent monitor issues in the field.
In this article, we’ll walk you through a step-by-step process to isolate the issue and verify whether your EF1 monitor, motor, or controls are working properly.
Whether you’re working with a monitor like the Hurricane, Monsoon, or Tornado, paired with a joystick and valve setup, this step-by-step guide will help you locate your issue.
Learn how to inspect, lubricate, and maintain your 1250 body Masterstream nozzle for smooth stream control, longer life, and reliable performance.
Learn how to lubricate and maintain the M-R2000 Masterstream nozzle. Step-by-step guide with tips on O-rings, pressure control, and recommended lubricants.
How to Replace the Motor on an EF1 Firefighting Monitor https://youtu.be/f9nT4xn-KdQ The EF1 electric firefighting monitor is known for its durability and high performance, but like any piece of equipment, it may need occasional maintenance. One potential repair is replacing either the horizontal or vertical motor. This step-by-step guide shows you how to safely and […]
Electronic firefighting equipment relies heavily on clean, consistent signals across their communication lines. If you’re running into comm issues in your system, a solid first step is to check voltage levels on those communication lines.
Replacing the motor on your Monsoon, Tornado, Hurricane, Typhoon, or Tsunami monitors is a straightforward job with the right tools and steps.
How to Properly Time the Gearbox on an RC Extend-A-Gun https://youtu.be/wCVocJAHwbI If you’re working on an RC Extend-A-Gun and need to replace the gearbox, one of the most important steps in the process is making sure it’s properly timed before installation. Proper timing ensures that the Extend-A-Gun operates smoothly and accurately once installed. This guide […]
This guide explains how to operate the manual override system on Task Force Tips (TFT) RC monitors, including the Monsoon, Tornado, Typhoon, Tsunami, Hurricane and the EF1 monitor.
How to Identify and Replace Your TFT Storz Coupling: A Complete Guide to 4-Inch and 5-Inch Repair Kits View Transcript In this video, we’re going to go over a couple of the Storz coupling repair kits or replacement kits that are available, should you need those. The ones we’re going to talk about today are […]