How to Program Oscillate on Flex® from a Controller

If your Flex Monitor has a wireless or panel-mounted controller, you can program oscillation patterns without using the SmartPlex App. This is ideal for in-field setups where quick deployment and directional sweeping are needed.

Step-by-Step Instructions

1. Enter Oscillate Program Mode
   • Hold down the Oscillate button on the controller for 5–10 seconds.
   • The controller will start flashing orange, indicating you’re in Oscillate Program Mode.
2. Set the First Oscillation Point
   • Move the monitor to the first desired position in your sweep.
   • Tap the Oscillate button once.
   • The controller will flash white, confirming the position is saved.
3. Set the Second Oscillation Point
   • Move the monitor to the second sweep point.Tap the Oscillate button again.A second white flash confirms the point is accepted.
   A minimum of two points is required for oscillation to function.
4. (Optional) Add More Sweep Points
   • Continue setting additional points using the same process.
   • Tap the Oscillate button once at each new position.
5. Exit Program Mode
   • Hold down the Oscillate button again for 5–10 seconds.
   • The controller will turn blue, signaling that you’ve exited programming mode.

Run Oscillate Mode

1. Start Oscillation
   • Tap the Oscillate button once.
   • The controller will glow solid orange, showing that the monitor is oscillating.
2. Observe the Sweep
   • The controller will flash white each time the monitor hits a programmed point.
3. Stop Oscillation
   • Press any button or joystick on the controller.
   • The controller will turn blue, confirming exit from oscillation mode.